|
Hydrogen/Hydrocarbon
Leak Detector/Monitor
Sample Stream Dryer |
88
|
 |
|
||
 |
The Hydrogen/Hydrocarbon Leak Detector/Monitor is useful for sniffing the fittings on your GC for leaking hydrogen or argon/methane. It can also be used for detecting leaking natural gas, propane, or other volatile hydrocarbons. Detection limit is approximately 500ppm. This leak detector/monitor is also useful for long term monitoring of hydrocaron concentrations in a flowing stream or static chamber. The sensor element is the same CCD that is used as a GC detector on SRI GCs. | ||
The leak detector/monitor is attached to your existing voltmeter to provide a digital readout. As the H2/HC concentration increases, the voltmeter numbers increase. By utilizing a voltmeter as a readout device, the cost of the leak detector/monitor can be kept low. Unlike other leak detectors which use a row of LEDs as a low resolution readout, the voltmeter's high resolution display allows the user to notice small changes which would be hard to see on an LED display.
The 110 volt AC unit comes with a 9 volt power supply, but can also run on battery power using any battery source with voltage between 8 and 15 volts DC. Power consumption is approximately 200 milliamps. The H2/HC leak detector/monitor can also be built into the Model 203 PeakSimple data system for longer term strip-charting, monitoring, or data logging.
|
8690-5600
|
Hydrogen/Hydrocarbon Leak Detector/Monitor (110VAC) |
$
295.00
|
| 8690-5510 | General purpose voltmeter |
$
69.95
|
| 8600-5655 | Model 203 PeakSimple Data System with Hydrogen/Hydrocarbon Sensor installed |
$
1,595.00
|
- Affordable EPA
Method 5035 Compliance
- Retrofit Tekmar,
O.I., and SRI Purge & Trap systems
- Thermostatted
and Mechanically Agitated VOA vial sleeve
- Heated Transfer Line
|
8670-5850
|
Sample
Stream Dryer
|
$
495.00
|
| Hydrogen/Hydrocarbon
Leak Detector/Monitor Sample Stream Dryer |
88
|